ZMAPPER Properties tab

[system]

Ok, I hope this is just a dumb question but unfortunely i think zbrush or my pc is messed up .
My problem is: Always when i open zmapper in zbrush 3.1, I can’t get the Properties tab to show up.
I only get to make the Normal map by pressing “P” or “C” on keyboard and I just figured it out by complete luck …

Can anyone help me ?

[marcus_civis]

The ZMapper interface won’t show up if there’s not enough room for it. Make sure you close the left and right trays before launching the plugin.

[system]

Marcus, you just SAVED my day! Thank you VERY much man!
(I was going NUTS about it…)
Now I can finally use all the functions in this amazing plugin!