ZBrushCentral

using the layer brush

ZBrush Usage Questions
#1

Heres what I want

when I use the layer brush I would like to set a height, which the brush wont exceed even if I stop sculpting and start again, so I can move around my model sculpt a bit, move around, sculpt a bit, and no where will the layer draw more height on areas I have already used the brush on… hope that makes sense

heres what I have

when I stop sculpting and start again the next pen stroke creates another height over the stuff I have already added…

so how do I adjust the brush to only work to one height?

ta

#2

If you store a morph target the layer brush will use that as the reference point, allowing for multiple strokes that do not build up.

If you know you need to use the morph target for another purpose at some point then you should draw your layered strokes on a Tool > Layer. Then you can resume adding layer brush strokes by turning off the Tool > Layer, storing a morph target and then turning on the Tool > Layer.

#3

thanks :smiley:
worked a treat.