Hello everyone.
Friends, today is the release of the new figure The Maker.
I’ll tell you briefly who he is.
His name is Reed Richards, he is a scientist. Once he was positive, but after experiencing a series of tragedies, he went crazy and became a supervillain. This character is an alternative version of Mr. Fantastic from the Fantastic Four in the Ultimate Universe.
For this statue, I made two heads. One with a closed helmet, and the other with an open one. I tried to show his madness in his face and eyes. And a crazy smile.
The base is in the style of his technologies. Note that there are two flashlights on the base, where you can insert light bulbs if necessary. This will be a cool backlight. And right in the center of the base there is also a place for a light bulb. The monitor can be printed from transparent resin. And I think you can also screw a couple of light bulbs into it so that it lights up.
The lower cylinder of the base in two versions. One is cut into halves, the other is whole. This is for those who do not fit in the printer.
The head with the helmet is separated to make it easier to paint. 2 heads and 2 helmets included. With an open face and a closed one.
And there are two options for the right hand. One with a clenched fist, and the other with an infinity glove.
In the archive, the figure is 1/6 - 330 mm in size. You can write to me in private messages if you need a different size.
I also made two variations of the right hand. One with just a clenched fist, and the other with a glove of infinity.
This is a fantastic character, I watched a lot of videos about him. I hope he will be shown in some Marvel movie.
This fanart is a September release and I hope I will have time to make a second character this month.
The figure is prepared for 3D print without supports.
Thank you!
