ZBrushCentral

Smooth Divide after Merge all? - ZB4

ZBrush Usage Questions
#1

After a Group Split then a Merge All
How do you get the mesh to Smooth Divide?


  1. Load ZTL
  2. Group Split
  3. Merge All

    4. Divide with Smooth = on is not smoothing.

Attachments

ZB4_SmoothDivide.jpg

#2

I can’t reproduce this problem. Check that the polys are not creased by Shift-clicking the Tool>Geometry>Uncrease button.

#3

That is a good suggestion, but it turns out it was a masking issue.

Checklist
Check that Masking is off!
Looks like a small part of one of the subtools had a mask on. not visible, but enough to cause this.

When the tools were merged, it would subdived but not smooth.