Slow Undo on Dense Subtools

[Prophecies]

Hello!
My question is about undo speed with higher rez subtools. Right now i am working on a few subtools that range between 9-30 million points. Usually anything over 10 starts getting slow, at about 1 second per undo. The 30 million point mesh takes about 3 seconds, which can get a little annoying.

Is there something I am doing wrong, a setting I can change? Or is this just normal?

Thank you!

P.S. I am running 64gb of ram, with a Ryzen 7 3700x processor.

[Spyndel]

The denser the mesh, the slower many aspects of program performance will be, yes. This is normal. I couldn’t say what else you might have going on contributing to the slowdown.