Hi,
I’m using zbrush 3.2 for mac OSX on a powerbook 15 inch.
My question is about saving when you are using zbrush’s retopologize tool. I have no issues if I complete my retoplogized mesh in one sitting without needing to quit the program. The question comes from when I am only able to finish part of it and then need to quit the program and open it up again.
When I bring up my mesh which I am in the process of retopologizing again, I’m not able to see my points on the surface as I click to make polygons. I see them just fine when I do the “A” preview, but not when I’m clicking again.
What am I missing in the steps of opening up a mesh I was in process of retopologizing and starting work where I left off?
Thanks for taking the time to read my post and for any help you can offer.