I have a model, with a few subtools. the I am trying to remesh.
I am experiencing a problem which is hard to figure out.
Before I set the remesh to go. I posed the fingers to separate them. so that the remesh would not fuse them together.
When I click remesh . it processes fine except- the result is based on the original meshes position before I posed the fingers. and has not wrapped around the fingers in the posed mesh.
It is as if zbrush is using a different mesh on screen from the one that is is to calculate the remesh.
I have tried exporting and reimporting the mesh, I tried duplicating it and deleting the old copy but the problem remains.
I also tried saving the tool and bringing it in to a new session. and the problem is the same.
I am perplexed.
Please any ideas or advice would be most welcome
Dan
Attachments
