So I had this happen… I masked of the jaw to place the teeth and then the mask was removed when I did some detailing bc I forgot to move it back… Any idea how I could move the jaw back again without reverting to an older file and loosing hours of work? I’m not using dunamesh so the jaw si just sitting there.
Personally I would just go back and import in the older version.
Then use project all to bring back your updated detailing work.
you could also isolate the chin and then grow visible until you have the part of the jaw you want
I recommend storing a morph target, working with layers or at the very least putting a polygroup on the jaw.