I bridged a couple of holes, cleaned up a few stray artifacts and this happens? If I turn off lsym, it all disappears. There is a section of the modal that is not there before the mirror and weld? Please help. I performed a fix mesh and did not help.
So far I have straitened out all the polys so when I close holes it is nice and flat, I deleted and re-bridged the entire edge that is going to get the weld. And I turned on double to see if I pick up any more stragglers, I did not. I can perform a dynamic subdiv? Still it only mirror’s the edge?
Do you have Local Symmetry turned on when performing the Mirror & Weld? If so, turn it off.
If I turn off local symmetry, the canvas clears.