It was a little rough for me at the start to understanding the movement when using the Canvas in ZBrush. I don’t think such features that allows you to recenter the document just in case I lose the mesh view. Is there a way to set up certain angles such as; front, back, side, above and below in terms of shortcuts to where I do not lose track of my mesh? I am aware of CamView, however zooming and panning the Canvas while trying to sculpt by turning the mesh around made navigating through ZBrush a little complicated. This is an issue for me because I would like to sculpt characters in ZBrush in reference to turnaround sheets. How do I go about this issue? Any response is helpful!