ZBrushCentral

How to disable a StartUp Document?

ZBrush Artworks
#1

Hi everybody,

I have set a startup document (and saw that this is only 2.5D)

So I want to disable it again. How can I do it?

Many thanks

#2

What? Every document is 2.5D until you put in a 3D object and turn on Edit. Care to elaborate a bit more?

#3

Hi zber,
yes I know that it starts in 2.5D (it just was a test)

But now I want to have it back like before (with an empty canvas at start up)
Do you know how to revert that?
Thanks

#4

Just create a new one and save as startup doc. It will overwrite the one you have.

#5

ok, sounds somehow logical … sorry for asking that stupid question ;))

#6

NP! wasn’t a stupid question, I just wasn’t exactly sure what you were after. :slight_smile:

#7

So, here is another small question:

Sometimes the document size is important (“grabDoc”).
Would it be any disadvantage to leave it always on 4096 x 4096?
Or will it slow down other tasks? (I tried of course but wasn’t sure if there is any difference)

Thanks

#8

Probably the only difference would be is that it would use more RAM, about 400 MB for 4096 x 4096. If you have lots of RAM, like 16 GB or more, it shouldn’t cause any slow-downs. After all, if your not working in 2.5D, the document doesn’t do anything except just sit there waiting for you to render.