??Corrupt ZTool??

[hosch]

Is there a way to “repair” a corrupt ZTool?

I found occasion to take a mesh that was previously split unified and reproject the details and now the newly unified mesh is constantly crashing.

I get crashes very often (about every 2 minutes) when using any type of masking and less often (about every 10 - 15 minutes) when not using masking.

I have no crashing with other models - only this new one.

[hosch]

Looks like I found a solution - I exported all subdivision levels out as objs and then reimported them all into a single ztool - then reprojected the details up on each level and to avoid problems with tight areas did not click “smt” when I divided the base mesh. So far so good:).