ZBrushCentral

zspheres symmetry (answered)

ZBrush Usage Questions
#1

Hi,

Sorry for stupid question, but I can’t make symmetric arrengement. See the pic below.
My first problem is when I create 3 L-shaped zsphere, and turn on the symmetry, the 3 zpheres aren’t on the symmentry axis (as you can see on the left pic), so when I make a tentacle to the left, its mirrored one isn’t the same length. How can I move the spheres to the symmetry axes?

My second problem is on the middle and right pic. I would like to make a zpshere exactly below the first one. I mean ‘below’: i want the second sphere center to be on the y axis of first sphere. Is there any options to snap the zpshere to an other zsphere axis (x,y or z)?

Thank you very much!

Here is my pic: z1.jpg

#2

as far as your first picture goes, once you draw your zsphere out and go into draw mode, do you move or scale it at all? Also try turning on symmetry before you try anything else. As for making the spheres the same there is no way that I know of. All you can do is turn on symmetry and when its at the center the two points will snap together, you can then begin to draw another sphere out and then hold down Alt and it will snap to the same size as your original. Then you should be able to draw it out straight down by holding Shift and it will move down. Hope that helps.

#3

I think the together snapped green circle will help much.
Thank you Adio38 for helping me!

#4

Just as a sidenote marypoppins, if you have any questions or problems, please post them in the Other Questions And Troubleshooting Forum. That way you don’t tie up a bottom row slot for people wanting to post thier work. It also better serves other people searching for solutions to thier problems. Thanks! :slight_smile:

#5

sorry, I confused the topics permanently…
thank you