Where is the zremesher update…in the p2 page aurick said next week! Where is?
ZRemesher will be receiving its own update next week.
any news?
Ehi any news? Any info?
“approximately” next week 
Intrigued to see what it does. Would love it of it could do really good low poly versions of hard body stuff
The update is about fixing some issues (mainly with curve strength). ZRemesher 2 already support hard surfaces in ZBrush 4R7.
I know it supports hard surface but it doesn’t do anywhere near a good enough job to replace manual
small_orange_diamond:D