i’ve watched the video about ZRemesher 2.0 ,But cannot figure out the difference between “KEEP GROUP” and “Freeze Group”???
From the documentation:
"Keep Groups
Tool >> Geometry >> ZRemesher >> Keep Group mode retains the existing boundaries
of each of the model’s PolyGroups to reproduce those groups in the retopologized
model.
Unlike Freeze Groups option (which retains the same topology along the PolyGroup
borders), the Keep Groups option alters the topology while keeping the boundary shape.
This results in a better topology flow."
The picture available in the mouseover tool tip should give you an idea. Basically Keep Groups will try to keep clear distinct edges along poly group borders. With the right settings, it’s useful for hard surface remeshing. Establish polygroups for creasing groups, and Zremesher will try to draw much cleaner lines and reinforce those borders than it did previously, resulting in crisper shapes.
Thanks for helping
small_orange_diamond
Could you point me to the video about ZRemesher 2.0 you mentioned?
Thank you!