ZBrushCentral

resolution and dynamesh problems

ZBrushCore Usage Questions
#1

I have sometimes a problem with Dynamesh, when i keep on dynamesh my model, half of the model disapear, - i dont now why. Lots of times its working, and then this happens.

Also sometimes i then instead subdivide, but soon hit a limmit, - I then wonder if i could change the mem, when i have reach the limmit to subdivide, - its beccause, the resolution, dont seem to be very high, and i cant get any sharp lines with the damstandard brush, its rather edgy. Can i raise the mem, in the end of my modelling, to get sharp details, and then reset it afterwards?

Hope you can help me.

Regards Frank Fenriz Denmark

#2

You can set the Preferences>Mem>MaxPolyPerMesh slider to a higher value temporarily. But the value is chosen by ZBrushCore based on your system specs so it’s not a good idea to leave it at a higher value. (Restarting ZBrushCore without storing the configuration will reset it.)

I don’t know why half of your model should disappear. If you have a project file that this has happened on, and can upload it somewhere like Dropbox, I will take a look.