Hi.
I recently upgraded to 4R8 and it’s all working fine but I get these 2 error windows upon start up. What should be done?
Thanks!
~T.~
Does the ZBrush version in the upper left say “4R8 P1” or just “4R8”?
That was a known bug, but I can’t be 100% sure that the P1 patch fixed it. The error’s are for the Sculpteo plugin to upload to a 3D printing agency. If you are not going to be uploading to them, then don’t worry about it for now because Pixologic was working on a patch to fix it.
The P1 patch came out a while ago and the installer you downloaded should have the patch already included. Make sure you have “4R8 P1”.
Hi, zber.
I downloaded the full installer and didn’t see choices for that. Should I uninstall/re-install?
~T.~
There were no choices. It automatically installs the P1 patch When you install ZBrush.
If it say’s 4R8 P1 you already have the patch installed.
Looks like that is what I have. ~T.~
Yep, you are good to go. If those error notifications are going to bother you, you can go to “ZBrush 4R8/ZStartup/ZPlugs64” and temporarily move “Sculpteo.zsc” file and “SculpteoData” folder somewhere else out of ZBrush.
I’m not using any of that right now and it’s just 2 more clicks to open the program. You say an upcoming revision will correct this so I am fine for now. Thanks.