hi there, I’ve been fooling around with creating an Insert Brush, and for the most part it’s been fine, but I need to change the orientation by 90 degrees (I made a chain link and at the moment they’re being placed side to side rather than end to end).
thanks
Rotate the meshes that you’re referencing for the brush.
The way you see it on the canvas when you make an “InsertMesh” brush is the same way it will be inserted when using the brush. If you are making a tri-part “InserMultiMesh” brush, then the part at the top of the canvas is the start of the curve and the bottom is the end of the curve.
yup, that does the trick. thanks guys 
I should point out that the way you originally had it oriented has it’s uses also. If you were making a chain link fence for example, or any kind of fence for that matter. What I meant by “wrong way” was only to your particular situation.