2 Weeks Ago
|
Reply Quote UserGallery ThreadGallery Post#1 |
|
New Member
Join Date: Sep 2009
Posts: 6
|
normal mapping help please
when i try to use zmapper it says that i have over 500 000 polygons and i cant use zmapper. what step did i forget to do?
|
|
|
2 Weeks Ago
|
Reply Quote UserGallery ThreadGallery Post#2 |
|
New Member
Join Date: Sep 2009
Posts: 6
|
oh and how can i keep the polygons as low as possible, thanks in advance.
|
|
|
|
2 Weeks Ago
|
Reply Quote UserGallery ThreadGallery Post#3 |
|
Senior Member
Join Date: Dec 2007
Location: Sydney, Australia
Posts: 198
|
500 000 polys for a base mesh is a bit high.
Although I assume you are trying to side step disp by using a high rez model plus normal map. you should reduce it down, then try again. btw to keep your options open leverage subdivisions to your advantage and start with a lo rez base mesh. From what i can glean zmapper works fine with a mesh under 100 000 but even better under 30 000...depend s on your hardware... Of course you can bypass the zmapper warning and continue. hope this helps |
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
