Trial and Error--Learning

[wenna]

I've started to experiment with adding eyes to a ZSphere model using projection Master. Just a quick model to insert eyes. Not bad but when I picked him up, there's these distrubed white lines on top of head... see pic... Is this I did something wrong? I did change to Plastic material.. is that it? I tried smothing, inflate.. all sorts and nothing gets rid of it. Any suggestion, I believe I was up to 5 in resolution, should I be higher maybe?

[Bas Mazur]

Try to re-paint that spot in PM with the material you used for the rest of the sculpture. When it has something to do with the polys, smooth it.
On the picture it's hard to see whats going on..

[wenna]

Thank you so much! Yep, it was the material of the eyes showing thru.. painted over with the other material and voilla! Problem solved! You have saved my sanity, thanks again!