ZBrushCentral

zRemesher guide brush won't draw lines

Hi all,

I watched a lot of tutorials where people draw theres “lines” with the zremesher guide brush. I am unable to get this tool working. I am new to this, I think I missed a basic option or something.

When I try to draw zremesher guides in freehand mode on my ~200k dynamesh model, it drawes edgy lines over it as if the model was 3k, and ignores them completele when clicking zremesh. (even with curve intensity 90%).

I would be really happy for some tipps :slight_smile:

It may be because you need to shrink the size of the brush! I know I struggled with getting the lines to draw at first because of this. id see a line go out, but it’d be long and disappear. This is because it was set too-big and wasn’t really able to grab the detailed topology.

I’ve added a sample below of my settings