ZBrushCentral

Unwanted crease/edge created at symmetry line

Hi, Sculptris newbie here. I’m trying to work through tutorials and I’ve noticed that on my computer a crease/edge is always created at the symmetry line, which isn’t the case in the tutorials. I can’t find anyone else mentioning that when googling on the issue, and I’ve tried all the settings I could think of. I’m using Sculptris Alpha 6 on Windows.

Does anyone have an idea?

don’t know sculptris much, but i’d guess the object is slightly off center, which would mess symmetry up. look closely at the brush points as they move over the mesh…if they are not covering the EXACT same area then you know the mesh is off center or slightly misshaped to begin with . in zbrush that can be fixed using “offset”. not sure about sculptris.