ZBrushCentral

Edge Loop to RZmesher Guide

Hej,

I was wondering if I can select existing edge Loops on my mesh and use them as RZmesher Guides.
Some loops of my existing Mesh are already pretty good, so I want them to stay the same.
It would be a super duper mega time boost, if I could just select them and use them as my RZmesher Guides, rather than slowly repainting them.

Cheers,
Phil

I believe Zremesher guides will follow polygroups. Start a guide near a polygroup and hold shift and it will make a complete loop around that polygroup again.

I believe Zremesher guides will follow polygroups. Start a guide near a polygroup and hold shift and it will make a complete loop around that polygroup again.

With the zRemesher Guide brush chosen, go to: Stroke palette > Curve functions

Click Frame Mesh

This will apply guides around groups, borders, creased edges (or any combination of those depending on which buttons are pressed)

fancy sauce