Hi guys, this is my first post at ZBC and i hope you like it.
Currently I'm taking the ZBrush-Certification-course with Ryan Kingslien and i made this brush as an assignment during the course. Nate Portner gave me the advice to post a tutorial here, so here it is



The geometry for the actual brush isn't subdivided so it is very rough and edged. The subdivided parts are shown in the bottom image. An extra is the wired hose, which i wanted to be part of the tentacles, but the polycount went to high so i decided to make an single brush out of it.

For this tutorial I only show the creation of the middle-section which is duplicated along the curve, because i had to rebuild the whole thing to take snapshots. Rebuilding the heads would take a bit longer.