First attempts !

[jcfalcoski]

My first attempt at a torso... i'm a begginer...


thanks in advance for the comments..

[jcfalcoski]

Female torso....
C&C are very welcome ! thanks !

[jcfalcoski]

any comments? tips? critics?

thanks

[Santis]

Repost the last image so the whole side is visible

[jcfalcoski]

Whole side? It is visible for me, whats going on for you?

[Santis]

Sorry, it was my browser...
Okay, so it's getting late here in sweden, and I'm really tired... but I did a quick paint over for the female. Hope it makes any sense!

[Yumme]

I am a beginner as well but I must tell you: if these are your first sculpts than you are good man... in my opinion the female is close to perfect based on the anatomy I know... the male one could
use some work at pectorals and on the lower abdomen muscles... But really, nice sculpts! Keep it up!

[jcfalcoski]

Sorry, it was my browser...
Okay, so it's getting late here in sweden, and I'm really tired... but I did a quick paint over for the female. Hope it makes any sense!

Yes man !! It does !! Thanks a lot !

[jcfalcoski]

I am a beginner as well but I must tell you: if these are your first sculpts than you are good man... in my opinion the female is close to perfect based on the anatomy I know... the male one could
use some work at pectorals and on the lower abdomen muscles... But really, nice sculpts! Keep it up!

They are my first sculpts man ! I dont get much time to pratice because i work so hard as an architect, that i dont get time to do what i want.. but i'm studying! Thanks for the comments !

[jcfalcoski]

I'm trying to get some expression, but i cant separate his lips, anyone has any tips for me? This one is going to bee Dr Doom... i hope hehe

[Yumme]

I would do a retopology and send it in 3ds Max or Maya and get a cut between his lips... After that you can extrude in order to create the mouth and if is any good for you, create the teeth and the tongue in that
extruded cavity you just created.

[jcfalcoski]

I would do a retopology and send it in 3ds Max or Maya and get a cut between his lips... After that you can extrude in order to create the mouth and if is any good for you, create the teeth and the tongue in that
extruded cavity you just created.

Thanks !

[jcfalcoski]

This is my version of Dr Doom, i'm just a begginer, i'm learning everyday! Thanks for the viewing, comments and critics!

They are welcome!

[jcfalcoski]

any feedback or tips please?

[jcfalcoski]

My first ET what do you guys think ?

Thanks !