Need help with symmetry

[MrZmey]

Hello!

I need make a symmetrical lines concave around circle.
But it draws convex stroke on the back part of the model and flat on sides..

Any suggestion? Thank You very much!

[Skadalilama]

Your mirror symmetry is not activated. Under the transform pallet, you see X, Y, Z, M, and R. M is your mirror, which, if on, will transform all strokes equally instead of pulling the mesh out in one direction.

[MrZmey]

Your mirror symmetry is not activated. Under the transform pallet, you see X, Y, Z, M, and R. M is your mirror, which, if on, will transform all strokes equally instead of pulling the mesh out in one direction.

no no, this is something else... my mirror symmetry is ON..
it just draw in one direction( not to the center of the model

- Thank You!

[dapharmer]

make sure u have the right symmetry axis' on.. and for what you're trying to do your best bet is to use masks and transpose... if you mask out the shape u want to etch in all sides and then set a transpose from the center of the bracelt outward.. u can move the indentation exactly as far in or out as you want and get nice clean lines

[MrZmey]

make sure u have the right symmetry axis' on.. and for what you're trying to do your best bet is to use masks and transpose... if you mask out the shape u want to etch in all sides and then set a transpose from the center of the bracelt outward.. u can move the indentation exactly as far in or out as you want and get nice clean lines

Thank for good advice, this is a nice way to do it. but I try to find why this not working as I did it in 3.5 version..

[zber2]