ZSHERE QUESTION

[JUSTNPROUD]

i have been trying to mask part of the mesh in order to increase resolution for detailing in a part of the mesh with no success.I used control+shift and also control drag.But when I increase the density in the adaptive skin slider-it applies the density to the whole mesh.is there another button for increasing density? is this the right way to go about this. :rolleyes: http://www2.zbrushcentral.com/uploaded_from_zbc/200407/user_image-1090407825mhg.jpg

[devilbunny]

In order to selectively increase the density of a mesh, it must be converted to an adaptive skin, meaning it will no longer be connected to your ZSpheres. So make certain you have your ZSphere preview skin just the way you want it, then convert to an adaptive skin, and you should be able to increase mesh density in just the area you want. Good luck.

[JUSTNPROUD]

Thanks. http://www2.zbrushcentral.com/uploaded_from_zbc/200407/user_image-1090421788mfn.jpg

[sirquadalot]

How does your 1st post relate to your 2nd post? Your second post NEEDS to be moved to the community forum.
:mad:

[Ron Harris]

You have mail. :)

Edit...

duh...you now have two mails...one with the image attached this time.

Ron