MyMistakes

[hyper1]

Hi,
I'm a newbie here. I'm going to be buying Z2, but I thought I'd bring myself
up to speed by practicing for a while on the 1.55b demo. I've run into some snags while modeling with ZSpheres.

1. The first issue crops up when I accidently make a copy while doing a rotation. I've read in the manuel and have figured out how I'm making the mistake. However, I still make that mistake. The problem comes in the second part: How do you get rid of the Copy!!!

2. I did accomplish a partial ZSphere model, so I saved it and quit the session. On returning to Zbrush I loaded my model so I could finish it. I could not figure out how to do that. The model loaded fine, but I could not enter the edit mode again! Its no big deal I can redo that model if there is a special way it has to be saved in order to edit it again.

I'm sure that all of these questions have been asked before, so if you could just point me to the answers I would appreciate it.
Thanks,
Gary Poole

[Baramin]

To answer that 2nd question, did you save the document or the tool ? If you want to save your model to work on it later again in 3D, you're supposed to use the Tool/Save menu.

for the 1st question, I'm not sure to understand the "copy by mistake" problem. The only times it has happened to me so far is when I started a new model and tried to rotate the first Zsphere/3Dobject/etc... before entering edit mode. In that case I usually just hit Document/New and start again as I just started Zbrushing anyway when it happens.

hope that helped, at least for the 2nd question.