Help! (marks and saving)

[PaRaSiTe]

Hi, im new here, first sorry for my bad english :(

I want to know, how do i select an objet after i marked it..
I made a Ball and marked it, than i made another ball and marked it to, how do i select the fist ball to edit it??

and i saved a model, when i openned it how do i Edit? :D thx

[Kruzr]

‘Morning PaRaSite . . . :)

You asked: " how do I select the first ball to edit it?? " You Can't!

What you want to do is = create your first ball on the screen, then place your Marker for it. Create a new layer & place your new ball on the new layer, then place the new Marker for it. Now when you want to edit the first ball, all you have to do is = select the first layer, clear it, select the first object or ball you created in Tools, & move your cursor over the first Marker on the first layer, left click & your first ball or object will re-appear on screen again. Now you can further edit the first object all you want to. This applies to all objects in all layers. If your using the Demo, then you can't save the object, if your using the full version, then you would always save each object after creating it.

You also asked: " and I saved a model, when I opened it how do I Edit? thx ".

If you load the model that was saved, all you have to do is to draw it on the screen, select "edit object = T key ", & start modeling away.

I hope this helps some & have a good one . . . :cool: Mark.

[PaRaSiTe]

Thx very much! :D

[PaRaSiTe]

Kruzr.. i marked, than i saved my model..
but when i close the progam, and open again( :P ) i openned my model, but i cant Edit!! :(
and there're no Tool like my Model.. to replace it and than edit the new one..
how do i edit a saved modellll :(
thx :)

ow, i saved as .ZBR (domument)

ps: sorryyyyy for my english :P

[Kruzr]

Hi PaRaSite . . . :)

1st: When you save a Document or project, using = "Document / Save As", the objects created during the project are NOT SAVED, with the document.

2nd: When ever you are creating or editing an object, you should save it often, ( just in case of a crash in Zbrush ), by selecting = "Tool / Inventory / Save As".

3rd; Before you save your Document, be sure you've placed a Marker for each of the object or objects in the project. When you re-open your Document, you would select the separate layer for the object you want to work on, clear that layer & use the Marker to re-draw that object, selected from the list of Tools, then select, "Edit Object = T" to get into edit mode, & continue modeling or editing.

After opening your saved Document, you would select, "Tool / Inventory / Load Tool", & go to the directory that you saved the object in, then load the object you want . . . . . that is assuming that you have saved the object before you closed Zbrush? Now you can draw that object back onto the screen, using the Marker you placed for that object & edit it some more.

Everything will fall into place easier, the more you continue to use Zbrush, & have a good one . . . :cool: Mark.

[PaRaSiTe]

Thxxx a Looootttttttttt Kruzr =*