Symmetry in Projection Master

[Stephen Green]

Hi,

is it possible to get Projection Master to paint symmetrically on a polymesh (even though the mesh is dropped at that point) or would you return to 3D mode and use Re-Symmetry?

Thanks,

Steve

[Northstarr]

Hi! I don't think you can use Symetry when you are using projection master, I was trying to get that last night and the only symetry you can get is front & back, and that only works if your model is still properly aligned symetrically, otherwise the back is just slightly off.

[ambient-whisper]

i just paint on one side- apply,
and use smart resym

[Stephen Green]

Hi,

I did try that (on a 2million poly model) and it just seemed to hang, any idea how long I should give it to do a smart resym on a dual 2.8, 1.5Gig RAM?

Thanks,

Steve