Making props

[Q-qeo]

I wont make some props like a blade
pipe and spring..
i have a manuel but it dont work this is
what the manuel says.

A Blade.

1. tool: Select Cube 3D
2. Intialize:Set Size X=10, Sides Count=8
3. Intialize:Set HDivde 128, VDivid 128
4. Deformation:Apply Rotate Y 90, SSkew 100
5. Deformation:Apply Size x 100 3 times
6. Deformation:Apply Flat-75, Click Unify.
7. Deformation:Apply Rotate Z 90,Rotate Y 90
8. Deformation:Apply Taper X 75, Rotate Y 90
9. Material:Select Textued Metal

Let me know if you have the same problem
and give me some advice....
Thanks :cool:

[Caliban Tiresias Darklock]

Somtimes it wont work if you draw the cube on the canvas first then adjust the deformations etc.


Try simply selecting the cube3d, then adjusting everything, THEN drawing it on the canvas.


I'm not too clear on what your problem is, but see if this helps.

[Q-qeo]

Caliban,
I do it in the same order en stil it
wont work.
Have you try it out???

[Kruzr]

[Q-qeo]

Thanks mark,
I try it again........... :(

[Mentat7]

Hi Kruzr,

Which X Y Z selection did you use on these two steps? I think this is where the problem is. I couldn't get it to work either.

4. Deformation:Apply Rotate Y 90, SSkew 100
6. Deformation:Apply Flat-75, Click Unify.

[Q-qeo]

Hey mark,

this is what I get,
please give me your advise..

Fred :mad: http://www2.zbrushcentral.com/zbc_uploads/user_image-1020720598fsz.jpg

[RC]

LOL...I get the same thing so i morph it in to something else like an ax.

[Kruzr]

[Q-qeo]

Wel it dont work Mark,
I do the same as yours.
GRRRRRRRRRR :mad: :mad:
What the meaning with "size X 100 3times.
what 3 times??? :rolleyes:

By Mark..

[Kruzr]

[thelonious]

I followed kruzrs notes and got this.

http://www2.zbrushcentral.com/zbc_uploads/user_image-1020727144bbk.jpg

[Kruzr]